Most settings can be manually transferred between Simplif圓D® and Ultimaker Cura, although many have different names. Refer to the Program Codes Cheat Sheet and Program Codes Guide for information on all the G-code and M-code commands used to operate the AON3D machine. Known unsupported M-code commands used by Ultimaker Cura: Generally, these commands are not necessary and ignoring them has no negative consequence, however AON3D cannot guarantee this is always the case. The user will be alerted on the Graphical User Interface (GUI)/web browser when one of these commands is encountered, and the command is ignored. Ultimaker Cura uses several G-code and M-code commands that are not supported on the AON3D firmware.
AON3D recommends checking the Tool Change Scripts in Simplif圓D® to replicate them in Ultimaker Cura per material. Note that the material profiles we provide for Simplif圓D® often have optimized versions of this script for specific materials and nozzle sizes. Set the nozzle size diameter for each hot end assembly.įor the Start G-code and End G-code scripts, you can enter our generic Tool Change Scripts for T0 and T1 (copied below). The user can use the End G-code script in Ultimaker Cura to power the build chamber heater OFF at the end of the print, just as with Simplif圓D®. Although the AON3D machine should already be set to the correct build chamber temperature before a print is started, the user must make sure that the temperature is correctly set. The user must manually set the build chamber temperature. The user should not check the Heated Build Volume” box, as Ultimaker Cura uses a different G-code command M141 for a heated build chamber than the AON3D M104 T2. Refer to Multi-Part Printing for additional information and details. This is only relevant when printing multiple parts one after the other, rather than layer-by-layer. The Printhead Settings distances are conservative to avoid collisions with the cooling tubes on the toolhead. The recommended End G-Code script commands is as follows: // End G-code
#Ultimaker cura gcode software#
The layer view of the software demonstrates the expected printing results (b) G-code and extracted csv files. Keep the Start G-Code script entry empty. The STL file is decoded and the Gcode is generated. For AON M2+ machines, set the Z(Height) to 565 mm.
0 kommentar(er)
